Anybus targets real-time industrial Ethernet

0

Swedish conglomerate HMS Industrial Networks has introduced the AnybusÆ NP40 ,a new network processor that handles communication between an industrial device and any industrial network.

The new processor is the core of HMS’s Anybus CompactCom 40-series in chip, brick and module formats. It is designed for demanding applications, especially targeting real-time industrial Ethernet.

The NP40 comes with support for all major Industrial Ethernet and Fieldbus networks. This means that a single hardware platform can support several different networks by simply downloading new firmware.

Consequently, there is no need to start a development project for each new network. The new technology makes life easier for device manufacturers since they can install a communication interface into a product and then simply download the firmware they need before sending their products off to the end customer. The NP40 enables very low latency, down to a few microseconds. It practically allows for zero delay between the network and host API.

“What we have seen over the past few years is that industrial Ethernet is now demanding more performance and a new architecture,” says HMS Chief Operating Office Jurgen Palmhager.

“The new industrial Ethernet networks are getting more and more specialised which requires a lot from a network processor that is to handle the ‘translation’ between different networks and protocols. In the NP40, HMS combines a powerful ARM Cortex M3 core with an FPGA fabric on the same chip, allowing both fast data transfer and real-time synchronization in hardware/FPGA.

“The solution is based on MicroSemi SmartFusion technology but integrates HMS’s unique blocks like our RTA (Real Time Accelerator) for industrial communication.”

The Anybus NP40 is a single chip network processor that includes a high-performance ARM core and an FPGA (Field-Programmable Gate Array) fabric.

The ARM core runs the protocol and application stacks while the FPGA fabric is used to implement the various real-time Ethernet interfaces. A real-time-switch is integrated into the FPGA fabric and it supports synchronous cyclic messaging in real-time networks such as PROFINET IRT, Powerlink, EtherCAT and Sercos III.

The network processor is fl ash-based, it can be re-programmed for several different industrial Ethernet networks.

The NP40 is built on technology from Microsemi Inc.

Share.